Mitsubishi Electric C80 Series Instruction Manual page 195

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus (when the cursor is at [ToolNo.] of [Disp details])
Menus
Switch the display data type of the detail view of tool management data by pressing the button.
Type
switch
Clear the tool management data of the currently selected tool number.
Tool
clear
Switch to the tool management data list.
List
view
This closes the pop-up window and quits this function.
Close
Menus (when the cursor is at [ToolType] of [Disp details])
Note
(1) For L system, the menus [Lathe turning] to [Lathing tap] are displayed on page 1, the menus [Ballendmill] to [Facemill]
are displayed on page 2.
Menus
Switch the display data type of the detail view of tool management data by pressing the button.
Type
switch
Select the [Ball endmill].
Ball
It is also selected if the value "1" is entered.
endmill
Select the [Flat endmill].
Flat
It is also selected if the value "2" is entered.
endmill
Select the [Drill].
Drill
It is also selected if the value "3" is entered.
Select the [Bulnoseendmill].
Bulnose
It is also selected if the value "4" is entered.
endmill
Select the [Chamfer].
Chamfer
It is also selected if the value "5" is entered.
Select the [Tap].
Tap
It is also selected if the value "6" is entered.
Select the [Face mill]. It is also selected if the value "7" is entered.
Face
mill
This closes the pop-up window and quits this function.
Close
Select the [Lathe turning]. It is also selected if the value "51" is entered.
Lathe
turning
Select the [Groove]. It is also selected if the value "52" is entered.
Groove
Select the [Thread cut]. It is also selected if the value "53" is entered.
Thread
cut
Select the [Lathing drill]. It is also selected if the value "54" is entered.
Lathing
drill
Select the [Lathing tap]. It is also selected if the value "55" is entered.
Lathing
tap
IB-1501453-C
Details
Details
170