Mitsubishi Electric C80 Series Instruction Manual page 189

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
List of display items for compensation data (Disp details)
Compensa- Compen-
tion data sation
(*1) Names set by the parameter "#1022 axname2" corresponding to the axis are displayed in "*** axis name".
(*2) If the number of axes in the part system is 2 or less, the name of non-existing axis is displayed according to the setting
of the parameter"#1281 ext17/bit1" (Selection of additional tool offset axis) as follows.
0: The axis name is not displayed.
1: The axis name designated by "#1028 base_K" is displayed in the 2nd axis, and the axis name designated by "#1027
base_J" is displayed in the additional axis.
(*3) When the parameter "#8117 OFS Diam DESIGN" is set to "1", the symbol "Φ" is displayed on the right side of the item
name.
(*4) When "#1019 dia" (Diameter specification axis) is set to "1" for the axis, the symbol "Φ" is displayed on the right side
of the item name.
IB-1501453-C
Display data
H No.
D No.
Length
L wear
Radius (*3)
R wear (*3)
Tool L offset num
Wear offset #
Length "1st axis name" (*1)(*2)(*4)
Length "2nd axis name" (*1)(*2)(*4)
Length "Additional axis name"
(*1)(*2)(*4)
Wear "1st axis name" (*1)(*2)(*4)
Wear "2nd axis name" (*1)(*2)(*4)
Wear "Additional axis name"
(*1)(*2)(*4)
Nose R (*3)
R-wear (*3)
Point
○: Display/setting enabled
Tool compen- Tool compen-
sation type I sation type II
○
-
○
-
-
-
-
-
-
-
-
-
-
-
-
-
-
164
-: Non-display
Tool compensa-
tion type III
○ -
○ -
○ -
○ -
○ -
○ -
- ○
- ○
- ○
- ○
- ○
- ○
- ○
- ○
- ○
- ○
- ○