Mitsubishi Electric C80 Series Instruction Manual page 116

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation method (Setting "COUNTER" as the variable name for variable No. 509)
(1) Select common variable 509 with the same procedure as steps (1) and (2) above.
(2)
Press the key.
(3) Input the variable name.
COUNTER [INPUT]
Note
(1) The variable name can be set only for variable No. 100 to 199 or 500 to 599.
Operation method (Copying and pasting the common variable)
(1) Select the variable to be copied.
One of the following methods can be used to select the variable.
Using the cursor movement key [↑], [↓],
Press [Var No search] and set the variable No. in the input area, and press the [INPUT] key.
(2) Press the menu [Copy].
(3) Select the variable to be pasted, and press the menu [Paste].
The copied variable is held until a variable is newly copied.
Operation method (Erasing the variable value for variable number 102 to 104)
(1) Press the menu [Variabl clear].
(2) Input the No. (range) of the variable to be erased.
102/104 [INPUT]
To erase only one variable, input one variable No.
(102 [INPUT])
(3) Press the [Y] key.
Note
(1) The variable at the cursor position will become the target of the erasing if the [INPUT] key is pressed without designating
a variable No.
(2) The variables in the range below are the erasing target when /E is designated.
Input example
100/E
400/E
(3) If you include a variable between 100s and 500s in the range designation, the erasing is not performed.
(Example) When you set "110/510", "setting error" is displayed and the variables are not erased.
, or
Erasing range
100 to 199
100100 to 100199 (when the displayed
part system is 1)
400 to 999
100100 to 800199
900000 to 907399
, move the cursor to the variable to be selected.
Supplement
Only common variable in the displayed part system
is cleared.
Range to be cleared varies depending on the num-
ber of common variable sets.
91 IB-1501453-C