Mitsubishi Electric C80 Series Instruction Manual page 422

C80 Series Instruction Manual
11 Performing a Backup Operation
Sub-menus of [Dir] (memory)
Menus
"Program" appears in the directory.
Program
The "File" column is blank.
"Program all" is displayed in the "Dir" column.
Program
The "File" column is blank.
all
"Tool offset" is displayed in the "Dir" column.
Tool
"TOOL.OFS" is displayed in the "File" column.
offset
"Variable" is displayed in the Dir column.
Variabl
"COMMON.VAR" is displayed in the "File" column.
"Workpiece offset" is displayed in the "Dir" column.
Coord
"WORK.OFS" is displayed in the "File" column.
offset
"All tool data" is displayed in the "Dir" column.
All T
"TOOLALL.DAT" is displayed in the "File" column.
data
"Parameter" is displayed in the "Dir" column.
Param "ALL.PRM" is displayed in the "File" column.
"System config" is displayed in the "Dir" column.
System
"ASSEMBLY.INF" is displayed in the "File" column.
config
"Safety parameter" is displayed in the "Dir" column.
Safety
"SAFEPARA.BIN" is displayed in the "File" column.
param
"Smp data" is displayed in the "Dir" column.
Smp
"NCSAMP.CSV" is displayed in the "File" column.
data
"System parameter" is displayed in the "Dir" column.
System
"SYSTEM.PRM" is displayed in the "File" column.
param
"Option" is displayed in the "Dir" column.
Option
"OPTION" is displayed in the "File" column.
The device can be selected from the sub-menu. (The devices that can be used will differ depending on the specifications.)
One of the following methods can be used to designate the directory (for devices other than the NC memory) and file name.
Designate the directory path (full path) or file name in the input area and press the [INPUT] key.
Press sub-menu [From list] of the menu [Dir] or [File name]. Move the cursor to the target directory or file name, and press
the [INPUT] key.
A wildcard (*) can be used when selecting a file name.
Notes when selecting a file
(1) During directory and file name setting, the designated directory, path or file name will be set, even if it does not actually
exist. This will not cause an error. Note that the previously set directory is overwritten.
(2) When a file in the NC memory other than a machining program is designated, it is not necessary to set the file name.
(The file name is fixed.)
(3) When a file name is selected from the menu, it first is displayed in the input area. However, at this time the file name
has not yet been fixed. Press the [INPUT] key again to fix the file name.
(4) If you press the key when setting a file name, the file name in the input area is erased.
(5) When selecting a fixed cycle program, it is necessary to set the basic common parameter "#1166 fixpro". Furthermore,
select "Memory" for the device, and "Program" for the directory.
Details
397 IB-1501453-C