Mitsubishi Electric C80 Series Instruction Manual page 268

C80 Series Instruction Manual
6 Setting Parameters
Display items
Display items
(1) During machining
condition
(2) Application name
(3) Application
(4) Std parameter
(5) Machining condition
parameter set
(6) Set
Menus
Menus
Switches machining condition to standard parameter.
Std
After the menu is highlighted and the cursor moves to standard parameter, the confirmation message
prmselect
"Change to standard parameters?(Y/N)" will appear. If you press [Y] (or [INPUT]), the status of standard
parameter changes to "Set".
If you press any key other than [Y] (or [INPUT]), it will be canceled. The cursor will remain on standard
parameter even when canceled.
Changes to the "Machining cond screen".
Cond
set
<Note>
MTB password is required for the maintenance screen.
This closes the pop-up window and quits this function.
Close
Displays the applications and conditions used for the current machining.
This shows No. 0 through 3 of the machining applications and conditions, which you
have selected on the [Machining condition selection] screen or switched with a G code
command.
While standard parameter is being selected, "0" is displayed on the applications and con-
ditions.
Displays the application name set in the menu [AppName set] in the "Machining cond
screen".
Displays Application 1 to 3.
"Set" is displayed in this column while the standard parameter is being selected.
Displays the machining condition parameter set of application 1 to 3.
"Set" is displayed in the column of the selected machining condition parameter set.
"Set" is displayed in the column of the selected machining condition parameter set.
It will not update if an application/condition is switched by G code command. It will update
when selected on the machining condition selection screen.
243
Details
Details
IB-1501453-C