Mitsubishi Electric C80 Series Instruction Manual page 84

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation method for registering MDI program
(1) Press the menu [MDI] on the edit screen.
(2) Select the program to register, and then press the [INPUT] key.
Note
(1) The program is registered as a general program of NC memory.
When the fixed cycle or MTB macro is selected with the parameter "#1166 fixpro" (Fixed cycleediting), the program can-
not be registered. The "Save not possible" message appears.
(2) Program cannot be registered while "Editing" is being displayed. The "Save not possible" message appears. Press the
[INPUT] key to be "MDI Set ended".
(3) When the general program remaining capacity is less than the value of MDI program to be registered, the program can-
not be registered. The "Memory over" message appears.
(4) When the number of remaining general programs is zero, the program cannot be registered. The "Program entry over"
message appears.
(5) When the [INPUT] key is pressed without entering the program name, "setting error" occurs.
(6) If the program name is input with only numbers when the parameter "#8936 Delete leading 0" is set to "1", the number
without the leading zero is registered as the program name. However, when a number without a leading zero is outside
the range 1 to 99999999, the leading zero is not deleted.
(7) If the input program name already exists in the NC memory, the MDI program cannot be registered during the operation
or program restart. The operation message "Executing automatic operation" or "Program restarting" appears.
If the program name is input with only numbers when the parameter "#8936 Delete leading 0" is set to "1", the pro-
gram is checked with the leading zero deleted. (Example: If the MDI registration is specified as "0001" when the
program "1" is in automatic operation, the "Executing automatic operation" message appears and the registration
cannot be performed.)
(8) When the input program name already exists in the NC memory and it is not being in operation, the "Overwrite this file?
(Y/N)" message appears. When the [Y] or [Input] key is input, the program name is overwritten, and when a key other
than those is pressed, the registration is canceled.
If the program name is input with only numbers when the parameter "#8936 Delete leading 0" is set to "1", the program
is checked with the leading zero deleted. (Example: If the MDI registration is specified as "0002" when the program "2"
already exists in the NC memory and it is not in the operation, the "Overwrite this file? (Y/N)" message appears.)
(9) When the program name to be input is subject to edit lock (edit lock B: 8000 to 9999, edit lock C: 9000 to 9999), the
message "Edit lock B" or "Edit lock C" appears, and the program name cannot be registered.
If the program name is input with only numbers when the parameter "#8936 Delete leading 0" is set to "1", the program
is checked with the leading zero deleted. (Example: If the MDI registration is specified as "008000" when the edit lock
B is valid, the "Edit lock B" message appears and the program cannot be registered.)
59 IB-1501453-C