Specifying Display Format And Setting Range Of Additional Information - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.5.11 Specifying Display Format and Setting Range of Additional Information

The display format and setting range of additional information can be changed by entering tool data file (TOOLALL.DAT)
described in the specified format.
[Setting]
No. Addresses
1 N Custom data No.
2 B Number of bytes
3 K Type
4 D Number of digits
5 L Maximum value
6 S Minimum value
Note
(1) When the illegal value is set, it is handled as 4 bytes, signed decimal data without range check.
[Setting example]
N1B1K0D0L100S-100
N2B0K4D33L999999S-999999
IB-1501453-C
Details Data range (Meaning)
1 to 12
0: 4 bytes
1: 1 bytes
2: 2 bytes
4: 4 bytes
0: Signed decimal
1: Unsigned decimal
2: Hexadecimal
3: Bit
4: With decimal point (fixed number of
digits)
5: With decimal point (linked with iunit
and I_inch)
6: With decimal point (linked with iunit)
7: With decimal point (linked with
I_inch)
8: Character string
0, 11 to 88
If the data is without decimal point, it is
set to "0" is set.
High-order is the number of digits of in-
teger part
Low-order is the number of fraction part
<Note>
Designate the data so that the total
of fraction and integer part does not
exceed 10 digits.
Specify the configurable maximum value and minimum value.
In case a check is not necessary, set that minimum value is larger than maxi-
mum value.
When the kind is character string, the number of characters shall be 0 to 4.
When the data with decimal point is selected for the kind, eliminate the decimal
point from the value when iunit = B, and I_inch = 0 (mm).
(Example 1) In case of 0.000 to 99.999
Minimum value: 0, Maximum value: 99999
(Example 2) In case of -99.999 to 10.000
Minimum value: -99999, Maximum value: 10000
Custom 1 to 12
Data with decimal point is valid
only when it is 4 bytes and digits
information is required.
Character string is valid only when
it is 4 bytes.
When the display data is linked
with iunit and I_inch, the number
of digits when iunit = B and I_inch
= 0 (mm) is set.
When I_inch = 0 (inch), the integer
part decreases 1 digit and the frac-
tion part increases 1 digit.
When iunit = C, the fraction part in-
creases 1 digit.
180
Supplement