Mitsubishi Electric C80 Series Instruction Manual page 108

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Operation to automatically open the searched machining program (When the 1st part system is set as the displayed
part system)
Currently selected Deselected editing area
editing area
A machining pro- A machining program is not
gram is not opened. opened.
For the conditions other than the above, no operation is performed.
(*1) For part systems other than the 1st part system, the 2nd part system is described as a typical one.
Note
(1) If the searched machining program is not registered in the displayed part system, it is not opened. When the searched
machining program is registered only in the displayed part system, no file is opened in the deselected editing area.
Operation method (Opening the existing machining programs of the same name in all part systems (When the 1st part
system is set as the displayed part system))
Perform the following procedure to open the machining program, "100", under the following conditions.
The parameter "#8977 Multi-$ simul edit" is set to "1" (valid).
The machining program, "100", is registered in all part systems of NC memory.
(1) Press the menu [Open].
(2) Use the [↑], [↓], [←], and [→] keys to align the cursor
with the target machining program (100), and press
the [INPUT] key.
The same operation can also be performed by input-
ting the machining program name (100) to be edited
in the input section and pressing the [INPUT] key.
Operation
A machining programs in the 1st part system is displayed in the
currently selected editing area, and that in the 2nd part system is
simultaneously displayed in the deselected editing area. (*1)
The list appears as a pop-up window.
The machining program "100" in the 1st part system is
displayed in the currently selected editing area, and the
machining program "100" in the 2nd part system is dis-
played in the deselected editing area.
83 IB-1501453-C