Mitsubishi Electric C80 Series Instruction Manual page 142

C80 Series Instruction Manual
4 Inputting and Outputting a Machining Program
(6) Press the menu [Program all].
When the file name is designated, only the top pro-
gram of transfer source is stored in the designated
file. For example of "Example of "the external device
-> NC memory" of machining program batch trans-
fer", when "TESTCUT" is designated as the transfer
direction file name, the top program is transferred as
not "1000" but "TESTCUT".
(7) Press the menu [Transfr A→B].
(8) Press the [Y] or [INPUT] key.
When the same machining program already exists in
transfer direction device, the operation message
"Overwrite this file?(Y/N)" appears. The transferring
the following program is continued by selecting [Y] or
[N] key.
(9) Press the menu [Compare A:B].
Note
(1) When programs are input in a batch to NC memory, always specify "Program batch" to NC memory directory as transfer
direction. If "Program batch" is not specified, one file is transferred (No batch).
(2) When the program which is subject to edit lock exists in transfer source, the message "Edit lock B" or "Edit lock C" ap-
pears, and transfer is interrupted. When the program which is not subject to edit lock is transferred, delete the program
which is subject to edit lock in transfer source. (Refer to "4.8.3 Edit Lock B and C".)
(3) When the protection of the machining program is valid, the program cannot be transferred/verified. (Refer to "4.8.5 Data
Protection Keys".)
(4) During the automatic operation, the program in program restart cannot be overwritten. The operation message "Execut-
ing automatic operation" or "Program restarting" appears, and transfer is interrupted.
(5) The first line of the transfer source file is ignored.
File transfer is commenced. Transmitting data is dis-
played in input data display column. The operation mes-
sage "Transfer complete" appears upon the completion
of transmission.
The file comparison starts. The verifying data is dis-
played. A message appears when the comparison is
completed. When the verification error occurs, the error
block is displayed in verification data display column and
the operation message "Compare error. Compare next
file?(Y/N)" appears.
117 IB-1501453-C