Mitsubishi Electric C80 Series Instruction Manual page 351

C80 Series Instruction Manual
9 Machining a Workpiece
(11) Set the position to restart search in the setting area.
Set the number of times which the block to be searched appears in "P".
For example, if a block in a subprogram is searched, and the subprogram is called out several times, the block to be
searched is also executed several times. Thus, which execution block to be searched must be set. (If "0" is set, it is
handled in the same manner as "1".)
To search the first execution block, or to search for a block executed only once, this item does not need to be set.
(12) Press the [INPUT] key or the menu [Search exec].
(*1) The maximum number of digits is eight for the sequence No. and five for the block No.
Note
(1) When the sorting of tool data is in progress, the operation message "Sorting of tool data is in progress" appears, and
the search cannot be executed.
IB-1501453-C
Delimit the ONBP number in the setting area using /.
<When O No. was attached>
The restart search is executed at designated position by
NBP No. with the set O No. at the head.
(Example) 123.PRG/6/2/1
<When O No. was not attached>
The program currently searched is targeted.
(Example) /6/2/1
Restart search is executed. (*1)
The message "Executing restart search" appears during
the search process, and the message "Restart search is
completed" appears when completed.
Each axis' restart position and the restart remaining dis-
tance are displayed.
When the menu [MSTB history] is pressed, the MSTB
history screen will open as a pop-up window, and the M,
S, T, B command used in the machining program will be
listed.
326