Mitsubishi Electric C80 Series Instruction Manual page 221

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Operation method (Setting the tool life data)
(1)
Move the cursor to the data to be set using the
It is possible to move to the line after the registered line.
(2) Input the value.
20 [INPUT]
Operation method (Copying/pasting the tool life data)
(1) Move the cursor to the line to be copied.
(2) Press the menu [Line copy].
(3) Move the cursor to the line where the data is to be pasted.
(4) Press the menu [Line paste].
Note
(1) Once copied, the data is held until a new data item is copied.
Operation method (Erasing one line of tool life management data)
(1) Move the cursor to the line to be erased.
(2) Press the menu [Line clear] and [INPUT] keys.
(3) Press the [Y] or [INPUT] key.
Press a key other than [Y] or [INPUT] in order not to erase the data.
Operation method (Designating and erasing the multiple lines)
(1) Press the menu [Line clear].
(2) Set the erasing range by marking the first and last # Nos. with a "/", and press the [INPUT] key.
122/125 [INPUT]
(3) Press the [Y] or [INPUT] key.
Press a key other than [Y] or [INPUT] in order not to erase the data.
Note
(1) If the [INPUT] key is pressed without setting a # No., the line at the cursor is erased.
IB-1501453-C
, , [↑], [↓], [|←] and [→|] keys.
196