Mitsubishi Electric C80 Series Instruction Manual page 271

C80 Series Instruction Manual
6 Setting Parameters
Setting the machining condition parameter set
(1) Press the menu [MacCond] in the setup screen.
(2) Select the menu [Cond set] in the "Machining cond" screen.
(3) Move the cursor to the position of the parameter to be set.
(4) Input the value, and then press [INPUT].
Note
(1) It cannot be set without initializing the machining condition parameter set.
Switching the machining condition parameter set
(1) Place the cursor on the position of the machining condition parameter set (application/condition) to be switched in
the "Machining cond" screen.
(2) Press the [INPUT] key.
(3) Press the [Y] or [INPUT] key.
Note
(1) The machining condition which is selected on the Machining cond screen applies to all part systems.
(2) When the machining condition parameter set is switched, for the parameter "#2010 fwd_g" (Feed forward gain) and
"#2659 tolerance", the same value is applied to all NC axes in the switched part system.
Canceling the machining condition parameter set and switch to standard parameter (Switch by cursor)
(1) Move the cursor to the standard parameter and press [INPUT] key on the "Machining cond" screen.
(2) Press the [Y] or [INPUT] key.
Canceling the machining condition parameter set and switch to standard parameter (Switch by menu [Std prmselect])
(1) Select the menu [Std prmselect] in the "Machining cond" screen.
(2) Press the [Y] or [INPUT] key.
IB-1501453-C 246