Mitsubishi Electric C80 Series Instruction Manual page 364

C80 Series Instruction Manual
9 Machining a Workpiece
(6) If the "Edit/Search" window is displayed while the automatic operation or restart search is in process in the selected part
system, message "Executing automatic operation" or "Program restarting" is displayed. However, when "#11039 Cusr
pos srch type" is set to "1", cursor position search is possible even in the single block stop state. For details, refer to
"Search during single block stop" in "9.5.1 Program Editing".
(7) If the "Edit/Search" window is closed during automatic operation or restart search in the selected part system, message
"Executing automatic operation" or "Program restarting" is displayed, but an operation search is not carried out. How-
ever, when "#11039 Cusr pos srch type" is set to "1", cursor position search is possible even in the single block stop
state. For details, refer to "Search during single block stop" in "9.5.1 Program Editing".
(8) If the "Edit/Search" window is opened while the operation mode is set to the MDI mode, the MDI program is displayed
in the "Edit/Search" window. In this state, if the "Edit/Search" window is closed, the MDI setting at the cursor position is
executed.
(9) The part system that is selected when the "Edit/Search" window is opened is to be searched when the "Edit/Search"
window is closed.
(10) The program that is searched when the "Edit/Search" window is opened is to be searched when the "Edit/Search" win-
dow is closed.
(11) In the following cases, edit/search is not available with the "Edit/Search" window. After an error is displayed, a blank
"Edit/Search" window is displayed.
Edit lock B, C is enabled
Operation search is not carried out
Edit file size exceeded
(12) If the edit/search signal is set ON at power ON, the "Edit/Search" window is displayed.
(13) The "Edit/Search" window cannot be closed with the cancel key. To open another window of the monitor screen, either
turn OFF the edit/search signal or use the direct screen selection in the menu list.
(14) If you switch to the monitor screen to edit using the direct screen selection while the "Edit/Search" window is displayed,
the "Edit/Search" window is closed once, a search is carried out, and then the "Edit/Search" window is displayed again.
(15) If the N number of the block to be searched exceeds the maximum value or is set to "0", it causes a search error in all
blocks that belong to the N number.
(16) If characters other than digits follow "N" of the block to be searched, "N**" of the program is handled as a normal block,
not a sequence number. Therefore, if the target block is searched, it is handled as a block that belongs to the previously
searched N number.
339 IB-1501453-C