Mitsubishi Electric C80 Series Instruction Manual page 213

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
Display items
(1) Group No.
(2) #
(3) Tool No.
(4) ST
IB-1501453-C
This is the group No. of the tool for which tool life management is per-
formed. (*1)
Tools with the same group No. are regarded as spare tools.
This is the data setting No. This is not the magazine pot No.
This is the No. corresponding to the each individual tool. Maximum
1000 tools can be registered.
This is a fixed tool No. actually output for the tool command and so on.
Tool status
MTB release
Tool status
0: Unused tool
Normally set to "0" when the tool is replaced with a new tool.
1: Tool in use
This becomes "1" when the cutting actually starts.
2: Normal life tool
This becomes "2" when the usage data (usage time and No. of uses)
exceeds the life data.
3: Tool abnormality 1 tool (*2)
4: Tool abnormality 2 tool (*2)
Details
188
Setting range
1 to 99999999
1 to 99999999