Mitsubishi Electric C80 Series Instruction Manual page 352

C80 Series Instruction Manual
9 Machining a Workpiece
Operation method (When the parameter "#8914 Auto Top search" is "1")
(Example) When restarting from subprogram O123 N6 B2 called from main program O1000
(1) Turn the power ON, and return all axes to the refer-
ence position.
(2) In the MDI mode, set the coordinate system to be
used when starting the program to be restarted.
(3) Move each axis to the program restart position.
(4) Press the main menu [Restart].
(5) Press the [Type 2].
(6) Press the sub-menu [File set].
(7) Select a device and press the menu key.
(8)
Press the [↑], [↓],
sor to the directory to which the file to be set belongs.
Press the [INPUT] key.
(9)
Press [↑], [↓],
the machining program to be edited.
(10) Press the [INPUT] key.
(11) Set the position to restart search in the setting area.
(12) Press the [INPUT] key or the menu [Search exec].
or key to move the cur-
or key to move the cursor to
The sub-menu is displayed.
The main screen for restart search appears as a pop-up
window.
The window for file set appears as a pop-up window.
Set the cursor to 1000.
The screen for restart search appears as a pop-up win-
dow.
Delimit the ONBP number in the setting area using /.
<When O No. was attached>
The restart search is executed at designated position by
NBP No. with the set O No. at the head.
(Example) 123.PRG/6/2/1
<When O No. was not attached>
The program currently searched is targeted.
(Example) /6/2/1
Restart search is executed. The message "Executing re-
start search" appears during the search process, and the
message "Restart search is completed" appears when
completed.
Each axis' restart position and the restart remaining dis-
tance are displayed.
When the menu [MSTB history] is pressed, the MSTB
history screen will open as a pop-up window, and the M,
S, T, B command used in the machining program will be
listed.
327 IB-1501453-C