Playback Editing - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables

3.7.4 Playback Editing

Edit
Edit
The playback function enables creation of a program while trying sample machining by manual (handle or jog) feed or me-
chanical handle feed. A machining program can be created with movement distance data obtained by manual operation
used as programmed command values.
The playback counter and valid address key (X, Y, U, V, etc.) are different depending on the parameter "#1076 AbsInc"
(ABS/INC address) setting. A parameter "#1076 Abslnc" can be set individually for each part system.
#1076 AbsInc (For L system only)
M system (This setting is meaningless.)
L system 0 (Absolute/incremental command depends
on G command)
1 (Absolute/incremental command depends
on address code)
<Absolute/incremental command depending on G command (M/L System)>
(1)
(2)
(3)
#1126 PB_G90
0 (Incremental value) Absolute/incremental command
depending on G command
1 (Absolute value)
(This setting is meaning-
less.)
Absolute/incremental command
depending on address code
77
Reference
IB-1501453-C