Mitsubishi Electric C80 Series Instruction Manual page 88

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables
Changing the display using the page up/down keys (
key: This displays one page of preceding lines of the current top line.
When there is less than one page of data, a page of data will be displayed including the data currently displayed.
The cursor moves to the last line of the screen.
key: This displays one page of following lines of the current bottom line.
The cursor moves to the top line of the screen.
Changing the display with the cursor key
The cursor will move up one line in the program each time the cursor key ([↑], [↓]) is pressed.
If the [↓] key is pressed at the top line of the program display area, the program will scroll up one line. If the [↑] key is pressed
at the end, the program will scroll down one line.
When a block is displayed over 2 or more lines, [↑], [↓] keys move the cursor by block unit.
1:N1 G28 X0. Y0. Z0.;
2:N2 G92 X0. Y0. Z0.;
3:N3 G00 X-300.
Y-300. Z-300.;
4:N4 G01 X-200. Y-200.
F2000;
11:N11;
12:N12 Z300.;
13:Y200.;
14:;
Move the cursor using the tab keys ( [|←]: back tab/ [→|]: tab)
[|←] key : Moves to the start of the word where the cursor is currently positioned.
If the cursor is at the start of a word, it moves to the start of the previous word.
[→|] key : Moves to the word after the word where the cursor is currently positioned.
Cursor destination when |
pressed
Cursor destination when |
key pressed again
Split display by word unit
The program is split by word unit and displayed.
: Previous page,
Cursor moves in same
display.
Display scrolls without
moving cursor position.
Current cursor position
key
3 N3 G00 X-300. Y-300. Z-300.;
4 N4 G01 X-200. Y-200. F2000;
: :
63
: Next page)
Cursor destination when | key
pressed
IB-1501453-C