Displaying The Life Management Data (L System: Tool Life Management I) - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.6.3 Displaying the Life Management Data (L system: Tool life management I)

The tool life management data can be set and displayed. Use the
registered tools cannot be displayed on one screen.
Display items
Display items
(1) #
(2) Time Used
Life
(3) Count Used
Life
(4) Status A
B
Menus
Menus
Copies one line of tool life management data where the cursor is located.
Line
copy
The copied tool life management data is written to the data in the line where the cursor is located.
Line
If the copied data is changed after the menu [Line copy] is pressed, the data before changing is written
paste
when pasted.
The copied data can be pasted as many times as is required until new data is copied.
This erases a designated line (multiple lines possible) of tool life management data.
Line
The first and the last line No. of the data to be erased is specified with a "/" separating the Nos..
clear
If the [INPUT] key is pressed without specifying a line, the data in the line where the cursor is located is
erased.
(2) (3)
(1)
Details
Tool No.
The # No. is highlighted if the usage time reaches the
life time or if the usage count exceeds the life count.
The integrated time the tool is used.
The count goes up during cutting.
Tool life time
Set the service lifetime.
Unit of second is set to "0".
The integrated count the tool is used.
The count goes up during cutting.
Tool life count
Set the service life count.
The tool life management status is indicated.
0: Not used
1: Current tool (tool being used)
2: Service lifetime (service life count) is exceeded.
(Used by MTB)
195
and keys to scroll between screens if all of the
(4)
0:0 to 99:59 (h:min)
0:0 to 99:59 (h:min)
(0:0 = no warning given)
0 to 65000 (times)
0 to 65000 (times)
(0:0 = no warning given)
0 to 2
0 to 99
Details
Setting range
IB-1501453-C