Mitsubishi Electric C80 Series Instruction Manual page 158

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
When measuring the tool length of the basic axis and inclined axis during the inclined axis control, the measurement basic
position (sensor position) is set on the sensor position within the orthogonal coordinate, not the position within the machine
coordinate.
(Example) When X axis is the basic axis and Y axis is the inclined axis.
Ｘ
θ
X: Actual X axis
Y: Actual Y axis
y: Orthogonal coordinate
θ: Inclined angle
Only Y axis travels
ｙ
Ｙ
133 IB-1501453-C