Mitsubishi Electric C80 Series Instruction Manual page 312

C80 Series Instruction Manual
9 Machining a Workpiece
Display items
Display items
(1)
Counter display
(2)
Currently executed machining program (*1)
Main
O10...
Sub
O1234...
(3)
Buffer display
This area displays the counter of the relative position or workpiece coordinate position.
If each axis is at a specific position or in a specific status, the following status abbreviations
are displayed.
#1 to #8: 1st to 8th reference position
][: Servo OFF state
MR: Mirror image
><: Axis removed state
CT: Auxiliary axis state
(Displayed when an axis that can be switched between the NC axis and auxiliary axis is set
to the auxiliary axis state.)
You can designate whether to consider the tool length compensation or tool radius compen-
sation depending on the value of the parameter "#1287 ext23/bit4".
The axis counter can be displayed or hidden depending on the value of the parameter
"#1069 no_dsp".
Also, if the axis is set to the diameter axis or uncontrol axis, the following symbol is displayed
on the right of the axis name.
*: Uncontrol axis (axis where any part system does not have control rights)
φ: Diameter axis
(When the target axis is equivalent to both the uncontrol axis and diameter axis, the symbol
of the uncontrol axis is displayed.)
Displays the currently executed program number, sequence number, and block number.
While a subprogram is executed, its program number, sequence number, and block number
are displayed.
This displays the contents of the machining program currently being executed.
The block being executed is highlighted.
When the parameter "#1122 pglk_c" is enabled, the contents of the program are not dis-
played. Only "%" is displayed.
<Note>
If the program comment includes the double-byte width character for one character
code, the program may not be displayed correctly.
Details
287 IB-1501453-C