Mitsubishi Electric C80 Series Instruction Manual page 245

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
The selected tool compensation No.
For the compensation No. of the tool length and tool nose wear data used by automatic calculation, the No. set in R register
in the following table is used.
#1098 Tlno. #1130 set_t
0 0/1
1 0
1
Note
(1) When the compensation No. is 0, the compensation amount will be calculated as "0".
(2) If the compensation No. exceeds the number of specified offset sets, the operation message "Offset No. not found" ap-
pears.
However, when the workpiece measurement screen is not displayed, the message will not appear.
(3) If the input data exceeds the setting range, the operation message "Data range error" appears.
However, when the workpiece measurement screen is not displayed, the message will not appear.
(4) If the data protection is valid, the operation message "Data protect" appears.
However, when the workpiece measurement screen is not displayed, the message will not appear.
(5) Whether to use the main side or sub-side is selected with the tool presetter sub-side valid signal.
(OFF: Main side, ON: Sub-side)
However, when the workpiece measurement screen is not displayed, the message will not appear.
(6) Set the compensation No. in R register by the BCD code.
IB-1501453-C
#1218 aux02 / Tool L offset num
bit4
Main side
0/1 R2600, R2601 R2604, R2605
0 R536, R537
1 R2602, R2603 R2606, R2607
0/1
220
Wear offset num
Sub-side Main side
R2600, R2601
Sub-side
R2604, R2605