Mitsubishi Electric C80 Series Instruction Manual page 229

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus
Menus
The results calculated from the measurement counter are set in the displayed workpiece coordinate sys-
Coord
tem offset. Only the axis for which a value is displayed in the measurement counter can be set.
write
<Note>
If the workpiece coordinate system to be set is G54 to G59, the local coordinate system offset value
will be zero. (Only for the measured axis.)
When the parameter "#8924 MEAS. CONFIRM MSG" is "1", this menu is highlighted and the oper-
ation message "OK? (Y/N)" appears. The measurement result is written as tool compensation
amount by pressing [Y] or [INPUT] key. Even if other key is pressed, the result is not written. When
this menu is pressed again while displaying the message, the highlighting is canceled and the op-
eration message is erased.
This selects the displayed workpiece coordinate system from the sub-menu (G54 - G59). Select the
Coord
workpiece coordinate system to display the selected workpiece coordinate system offset in the coordi-
G54-G59
nate system offset section.
(Perform the offset amount setting at the menu [Coord write].)
Input the P number to display the selected extended workpiece coordinate system (G54.1 Pn) offset in
Coord
the coordinate system offset section.
G54.1 P_
(Perform the offset amount setting at the menu [Coord write].)
This menu is not displayed if the extended workpiece coordinate system offset specification is disabled.
This displays the external workpiece coordinate system offset in the coordinate system offset section.
Coord
(Perform this setting at the menu [Coord write].)
EXT
This creates a false signal when performing simple measurement (measurement without using the
SkipPos
touch probe) and reads the skip position. Press this menu to display the measurement position mea-
take in
sured from the machine position of the axis moved last (axis 1 or 2) at the measurement counter.
The skip position cannot be read for an axis of auxiliary axis state.
This enables surface measurement.
Face
Surface measurement is possible when the power is turned ON.
meas
This enables hole measurement. (The cursor moves to the measurement counter point A.)
Hole
meas
This enables width measurement. (The cursor moves to the measurement counter point A.)
Width
meas
This enables rotation measurement. (The cursor moves to the measurement counter point A.)
Rotate
measure
This changes the axes displayed at the coordinate system offset and measurement position counter ev-
Next
ery 5 axes.
axis
<Note>
This displays when the number of enabled axes is 6 or over.
This sets the center shift amount. (The cursor moves to the 1st axis of "C shift (S)" when this is select-
Center
ed.)
shift
This sets the coordinate rotation center. (The cursor moves to the 1st axis of "Coord center" when this
Rotate
is selected.)
center
This sets the coordinate rotation angle. (The cursor moves to "Coord rot angle" when this is selected.)
Rotate
angle
IB-1501453-C
Details
204