Table of Contents
Advertisement
MITSUBISHI CNC
3 Setup Screens
3.4.2 Setting the PLC Command
Operation method (Setting the PLC command)
Set the value after the [PLC command] menu.
(1)
[PLC command] 12 [INPUT]
(Note)
Select the [PLC Command] menu again before pressing the [INPUT] key, then the menu highlight returns
to normal, and the PLC command setting mode becomes disable.
Press the menu [PLC command] , or the
(2)
again to finish setting.
3.4.3 Setting/Erasing the Tool No. of Spindle/Standby Tools
Operation method (Setting the tool No. of spindle/standby tools)
(1)
Press the [Spindle standby] menu.
(2)
Move the cursor to the data to be set using the [ ↑ ],
[ ↓ ] keys.
(3)
Input a new tool No.
50
[INPUT] (Note1)
Press the [Spindle standby] menu again or
(4)
to quit the spindle/standby setting mode.
(Note 1) When the [Spindle standby] menu again or
standby setting mode will be cancelled and the set data will be ignored.
(Note 2) Move the cursor with
Operation method (Erasing the tool No. of spindle/standby tools)
(1)
Press the [Spindle standby] menu.
Move the cursor to the tool No. to be erased and
(2)
input "0".
0
[INPUT]
(Note 1) Move the cursor with
I - 170
The set value displays in the PLC command setting field, and
the PLC command setting mode is enabled.
The function of the command depends on the machine tool
builder's specifications.
The PLC command setting mode is released, and the menu
key
highlight returns to normal.
The cursor appears at the top tool No. of spindle/standby.
In addition, the first "D" column is highlighted.
The tool No. changes. The cursor moves to the next tool No.
key
The spindle/standby setting mode is cancelled.
key is pressed before pressing the [INPUT] key, the spindle/
key to set the "D" data.
The cursor appears at the top tool No. of spindle/standby.
In addition, the first "D" column is highlighted.
The tool No. of spindle/standby changes to "0".
key and set "0" to erase the "D" data as the same manner as the tool No.
Advertisement
Table of Contents
