Mitsubishi Electric C80 Series Instruction Manual page 161

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
(4) Guide graphic
Tool compensation data Displays the tool compensation data.
(5)
Note
(1) The values of "Measure posn" and "Prg zero offset (L)" will be cleared when changing of part systems, screens and
measurement modes are carried out.
(2) When the parameter "#11017 T-ofs set at run" (Tool compensation amount setting during automatic operation enabled)
is set to "1", the tool compensation amount data can be set even during automatic operation or operation pause.
IB-1501453-C
Displays the measurement image. The contents of the guide drawing will differ de-
pending on which measurement type (Manual tool length measurement I or II) is se-
lected.
<Manual tool length measurement I>
Normal operation mode
The guide drawing is switched to the axis pointed by the cursor in the tool com-
pensation data.
Simple operation mode
The guide drawing is switched to the selected axis, when the handle mode is se-
lected.
<Z axis>
<Manual tool measurement II>
The guide drawing when using the touch probe is displayed.
<Note>
Cursor movement, data input and part system changing operation are same as
"Tool compensation type III (L system)".
Automatically jumps to the compensation No. registered in "Tool No. (Tool length
measurement 2)" (PLC device) during manual tool length measurement II. (Jumps
even when the wear data is being displayed.) Note that the [↑], [↓],
keys are disabled.
136
Details
<Other axes>
and