Program Editing Support Function; Performing Operation Search At The Cursor Position - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
3 Inputting a Machining Program and Defining Variables

3.7 Program Editing Support Function

Edit
Edit

3.7.1 Performing Operation Search at the Cursor Position

By pressing the menu [Cursor OP srch] when the device is in the normal status (not being in status such as editing or char-
acter searching, etc.), operation search of the selected part system is carried out starting.
(1) Select the part system that the cursor operation
search is performed.
(2) Open the program on the edit screen.
(3) Move the cursor to the block to be carried out the cur-
sor operation search.
(4) Press the menu [Cursor OP srch].
Note
(1) When the parameter "#1285 ext21/bit0" (Multi-part system program management) is set to "1" (valid), the menu [Cursor
OP srch] is disabled and the cursor operation search cannot be performed.
(2) During program editing, the menu [Cursor OP srch] is disabled and the cursor operation search cannot be performed.
(3) During the MDI program is displayed, the menu [Cursor OP srch] is disabled and the cursor operation search cannot be
performed.
(4) During automatic operation or restart search by selected part system, the cursor operation search cannot be performed
displaying the messages "Executing automatic operation" and "Program restarting" for each status.
In such cases, the display does not transit to the monitor screen. However, it is enabled when the parameter "#11039
Cusr pos srch typ" is set to "1" even if the operation is under single block stop. For details, refer to "Search during single
block stop" in "9.5.1 Program Editing".
(5) During automatic operation or restart search by other than the selected part system, the cursor operation search can be
performed, and the messages "Executing automatic operation" and "Program restarting" will not appear. In this case,
the display transits to the monitor screen.
IB-1501453-C
The program edit window appears.
Operation search is carried out starting from the block
that the cursor is positioned.
During the search "Searing" will display blinking.
After search is completed, the display returns to the
monitor screen.
74