C80 Series Instruction Manual
2 Screen Operations
Precautions for G code guidance
(1) G code guidance may be refreshed when the cursor is located near the comment.
(Example)
( PROG01 ) ;
(2) When the cursor is located at the axis address, etc., the guidance for the nearest G code is displayed even if the address
has no relationship with the G code.
(Example)
G01 G90 X100. ;
(3) When moving the cursor to the block with no G code as follows, the contents of the G code guidance will differ depending
on the cursor's route even if the cursor is in the same block.
(Example)
N01 G91 G01 X100. F1000
N02 100. Z100.
↑
N03 G02 X50. Y50. R50. ;
(4) G code could not function though the guidance is displayed.
(5) Basically, the G code format in the G code guidance is displayed using the format of 3-axis specifications of X, Y, and Z.
(6) Whichever plane is selected among the plane selection functions G17 to G19, the display data in the guidance is dis-
played using X-Y plane (G17) format.
(7) When the G code command includes an address that has two or more meanings, both contents is displayed.
(8) G code guidance will not be refreshed while the character string is searched or replaced.
(9) If "cmdtyp" varies in each part system for the L system, the display is switched to the guidance of the corresponding part
system when the part system is changed during the G code guidance display.
The guidance for G01 is displayed.
G code that has a relationship with "X100." is "G01", however,
G code guidance for "G90" is displayed.
When the cursor is moved by the route "a", the guidance for
G01 which is displayed last in N01 block is also displayed in
↓
N02 block.
When the cursor is moved by the route "b", the guidance for
← ... a
G02 which is displayed last in N03 block is also displayed in
N02 block.
33
IB-1501453-C