Disabling The Setting Of Tool Compensation Amount - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.4.6 Disabling the Setting of Tool Compensation Amount

Depending on the setting of the parameter "#8933 Disable lngth comp"/"#8934 Disable wear comp", the setting of the shape
compensation amount/wear compensation amount is disabled.
Depending on the tool compensation type, different operation will be disabled.
Tool compensation type
Type I ----
Type II ----
Type III "Wear"
"Length"
"Nose"
IB-1501453-C
"#8933 Disable lngth comp" = "1"
The menus [=Input], [+Input], [Line copy],
[Line paste], [Line clear], and [Undo] are
grayed out and cannot be selected.
Any setting by [INPUT] key is disabled.
The menus [Line copy], [Line paste], and
[Line clear] are grayed out and cannot be
selected.
The length and radius setting by [=Input],
[+Input], and [INPUT] keys are disabled.
----
The menus [=Input], [+Input], [Measure],
[Line copy], [Line paste], [Line clear], and
[Undo] are grayed out and cannot be se-
lected.
Any setting by [INPUT] key is disabled.
The menus [Line copy], [Line paste], and
[Line clear] are grayed out and cannot be
selected.
The nose R setting by [=Input], [+Input],
and [INPUT] keys are disabled.
154
"#8934 Disable wear comp" = "1"
----
The menus [Line copy], [Line paste], and
[Line clear] are grayed out and cannot be
selected.
The length wear and radius wear setting
by [=Input], [+Input], and [INPUT] keys are
disabled.
The menus [=Input], [+Input], [Line copy],
[Line paste], [Line clear], and [Undo] are
grayed out and cannot be selected.
Any setting by [INPUT] key is disabled.
----
The menus [Line copy], [Line paste], and
[Line clear] are grayed out and cannot be
selected.
The R wear setting by [=Input], [+Input],
and [INPUT] keys are disabled.