Mitsubishi Electric C80 Series Instruction Manual page 168

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
[Tool compensation type I] (M System): Parameter "#1037 cmdtyp" = 1
The combined amount of the shape compensation and wear compensation are set as the compensation data, with no
distinction between shape compensation memory and wear compensation memory. (The tool compensation data is the
shape compensation amount + wear compensation amount.)
The compensation data is used commonly for the tool length compensation, tool position offset, tool radius compensa-
tion, and three-dimensional tool radius compensation.
[Tool compensation type II] (M System): Parameter "#1037 cmdtyp" = 2
The shape compensation amount and wear compensation amount are set separately. The shape compensation amount
is furthermore divided into length and radius dimensions.
Of the compensation data, the length dimension data is used for the tool length compensation and tool position offset,
and the radius dimension data is used for the tool radius compensation and three-dimensional tool radius compensation
(compensation vector designation).
143
(1)
(1)
IB-1501453-C