Setting The Coordinate System Offset Amount - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.8.1 Setting the Coordinate System Offset Amount

Operation method (Setting the workpiece coordinate system G54 - G59 offset amount)
(1) Press the menu [G54-G59].
(2)
Use the (
workpiece coordinate system offset to be set.
Use the and
ordinate system display.
Refer to "Changing the coordinate system offset us-
ing the page up/down keys (previous page:
next page: )" in "5.8.4 Changing the Coordinate
System Display" for details.)
(3) Use the [↑] or [↓] key to move the cursor to the axis
for which data is to be set.
(4) Set the offset amount.
122 [INPUT]
The value can also be designated by pressing the
menu [=INPUT] instead of the [INPUT] key.
(5) Set other data using the same method.
Note
(1) It is possible to perform incremental input by pressing the menu [+INPUT] key instead of the [INPUT] key or the menu
[=INPUT].
(Example) If the original data is 122.000:
1.234 [+INPUT] -> 122.000 + 1.234 = 123.234
Setting the external coordinate system offset amount
Set the external coordinate system offset amount to keep the current workpiece coordinate system offset amounts from
G54 to G59, and also apply an offset to the entire system.
Furthermore, it is also possible to use the data transfer function to write data directly to the external coordinate system offset
(EXT). (Refer to "Chapter 11 Performing a Backup Operation" for details of the data transfer function.)
) keys to move the cursor to the
page keys to change the co-
The G54 - G59 workpiece coordinate system offset dis-
plays.
,
223 IB-1501453-C