Mitsubishi Electric C80 Series Instruction Manual page 30

C80 Series Instruction Manual
1 Outline of Menu Items
Edit screen
Menus
This edits a machining program.
Edit
This inputs and outputs the program between the NC internal
memory and the external input/output device.
I/O
<Note>
This menu is not displayed when the parameter "#8923
Hide Edit-IO menu" is set to "1".
Diagnose screen (Diagn)
Menus
This displays the hardware and software (software No. and
version) configurations.
Config
This displays the details of the additional specifications reg-
istered in the NC memory.
Option
This sets and displays input/output signals of the ladder
program.
I/F dia
This displays drive diagnostic information (servo/spindle/
power supply unit).
Drv mon
This sets and displays NC internal data.
Mem dia
This displays a list of currently occurring alarms and their
messages.
Alarm
This displays the status of the hardware and operation
stop.
Selfdia
This displays the hardware and operation stop state.
NC Smp
This executes the diagnosis related to functional safety.
<Note>
Safety
This menu is displayed when the parameter "#1481
Enable S-safety" (Enable smart safety observation) is
set to "1".
Details
Details
5
Reference
3 Inputting a Machining Program and
Defining Variables
4 Inputting and Outputting a Machining
Program
Reference
10.2.1 System Configuration Screen
10.2.2 Option Display Screen
10.4.1 Displaying and Setting the PLC De-
vice Data (I/F Diagnosis Screen)
10.2.3 Drive Monitor Screen (Servo Unit)
10.2.4 Drive Monitor Screen (Spindle Unit)
10.2.5 Drive Monitor Screen (Power Supply
Unit)
10.2.6 Drive Monitor Screen (Synchronous
Error)
10.2.7 Clearing the Alarm History on Drive
Monitor Screen
10.4.2 Writing and Reading the Data Using
the NC Data Designation (NC Memory Di-
agnosis Screen)
10.1 Confirming the NC Message (Alarm
Screen)
10.3.1 Self Diagnosis Screen
10.4.3 Collecting the NC Data (Data Sam-
pling Screen)
10.5 Safety Observation
IB-1501453-C