Switching The Stored Thread Groove On/Off; Erasing The Stored Thread Groove Position - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
8 Other Setups

8.6.2 Switching the Stored Thread Groove ON/OFF

Operation method
(1) Press the menu [Thrdrecut ON] while "Re-thread po-
sition specified" is ON.
(2) Press the menu [Thrdrecut OFF] while "In re-thread
cutting" is ON.

8.6.3 Erasing the Stored Thread Groove Position

Operation method
(1) Press the menu [All axs clear].
(2) Press the [Y] or [INPUT] key.
The thread cutting status is changed to "In thread recut-
ting".
In this state, retract the tool and start the thread recutting
program to enable the same thread machining as that
carried out for the original thread.
The re-thread cutting status returns to the "Re-thread
position specified" status, and thread recutting is dis-
abled.
The menu [All axs clear] is highlighted.
A message displays confirming whether it is okay to
erase the data.
The lead axis machine position (Z1) or the spindle angle
(S1) is cleared to "0".
273 IB-1501453-C