Mitsubishi Electric C80 Series Instruction Manual page 148

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
Display items
(1) Magazine
(2) Tool No.-D
(3) Spindle/Wait
(used by PLC program)
(4) PLC command
Menus
Menus
Magazines are displayed sequentially with the selected pot number on the top of them.
Pot No
The cursor moves to the data of the configured pot number, and tool number can be entered.
search
This sets or erases the tool No. of spindle and standby tools.
Spindle
The cursor will move to the top tool No. of the spindle and standby tools and the setting mode will be
standby
entered.
This erases all the currently selected magazine tool data (tool number and D).
Magazn
clear
<Note>
Unselected magazine tool data is not erased.
The spindle and standby data cannot be erased.
This designates the magazine No. to be displayed on the screen.
Magazn
The displayed menu differs according to the machine specifications. For example, when there are two
1
magazines, only the menus [Magazine 1] and [Magazine 2] display.
:
Magazn
5
The cursor moves to the PLC command setting area and the mode changes to the setting mode.
PLC
command
Tool registration duplication check
When the tool No. is set to the magazine pot and the spindle/standby, tool registration duplication can be checked. Either
of "Executing the duplication check for all valid magazines", "The duplication check invalid" or "Executing the duplication
check only in the selected magazine" can be selected by the parameter "#8922 T-reg-dup check".
<Priority of duplication check>
Operation
Register tool to magazine pot
(Refer to "5.2.1 Registering a
Tool in the Magazine Pot".)
Set tool No. to spindle/standby 1. Spindle/standby
(Refer to "5.2.3 Setting and
Erasing the Tool No. of Spindle/
Standby Tools".)
When the value of the parameter "#8922 T-reg-dup check" is out of the range, the check of setting "0" is performed (Exe-
cuting the duplication check for all valid magazines).
This displays the currently selected magazine No.
A maximum of 8 digits of data can be input for a tool No.
(Refer to the manual issued by the MTB for details on the "D" functions and pur-
poses.)
When the "Tool No." column is blank, confirm the tool first, since the tool could not
be mounted, or the tool could not match the spindle.
Setting "0" erases the registered tool.
This displays the magazine 1 spindle or standby tool No.
(The name of this area differs depending on the output from the PLC program.)
This command is used to input data and perform sequence processing using the
PLC program.
Setting of the operation parameter "#8922 T-reg-dup check"
0: Executing the duplica-
tion check for all valid
magazines
1. Magazine n (n =1,2...)
2. Spindle/standby
2. Magazine n (n =1,2...)
123
Details
Details
1: The duplication check
invalid
The duplication check is not
executed.
The duplication check is not
executed.
2: Executing the duplica-
tion check only in the se-
lected magazine
1. Selected magazine
2. Spindle/standby
1. Spindle/standby
2. Selected magazine
IB-1501453-C