Mitsubishi Electric C80 Series Instruction Manual page 50

C80 Series Instruction Manual
2 Screen Operations
Restrictions
(1) Always use "=" for the first character.
(2) Do not use the following characters as the second character or last character.
Invalid as second character: * , /, )
Invalid as last character: * , /, (, +, -
(3) Make sure that the left parentheses and right parentheses are balanced.
(4) The 360° limit does not apply on the angle. SIN (500) is interpreted as SIN (140).
(5) While the monitor screen or the setup screen displaying, if the axis name address, M, S, T, 2nd miscellaneous function
code (B, etc.) is pressed when "=" is set in data setting area as the first character, the operation input is given to priority.
So, the window does not open, and the cursor does not move.
(6) The exponential setting, like "1.23E-4", cannot be used. The operation result is not displayed with exponential.
(7) It is not possible to set characters exceeding the number of characters which can be input to the data setting area.
(8) It is not possible to omit "0" before the decimal point, like ".5", when operation inputting. An error will occur.
(9) The accuracy is guaranteed for the calculation with 15 digits or less. The calculation with over 15 digits does not guar-
antee its accuracy.
(10) The operator or the function which does not exist in the above-mentioned, such as "ASIN", cannot be used. The oper-
ation message "Setting error" appears, and the display of the data setting area does not change.
(11) Regardless of the input setting unit and metric system/inch system, the digit numbers below the decimal point of the
operation result is seven digits or less.
25 IB-1501453-C