Setting And Measuring A Workpiece; Workpiece Measurement (M System) - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.7 Setting and Measuring a Workpiece

5.7.1 Workpiece Measurement (M System)

Setup
W-meas
The coordinate point for each axis can be measured on the workpiece measurement screen of the Setup screen. Install the
sensor on the spindle, turn the measurement switch ON, and select manual feeding or handle feeding on the workpiece
position measurement screen to bring the sensor into contact with the workpiece. Then, measure the coordinate point of
each axis.
To make surface, hole, and width measurements, calculate each center coordinate from the measured coordinate, and set
the obtained value to the workpiece coordinate system offset.
For the rotation measurement, the measurement result is set in the workpiece coordinate system offset (rotation center)
and parameters "#8623 Coord rot centr(H)", "#8624 Coord rot centr(V)", and "#8627 Coord rot angle".
For surface measurement (As for the hole or width measurement, the guide drawing (3) differs.)
(1)
(4)
(5)
For rotation measurement
(1)
(7)
(8)
(9)
Manual numerical value command can be executed when manual numerical value command window is displayed by input-
ting an address key such as MST, etc.
IB-1501453-C 202
(2)
(3)
(6)