Mitsubishi Electric C80 Series Instruction Manual page 363

C80 Series Instruction Manual
9 Machining a Workpiece
Edit/search signal search
This is enabled when "2" or "3" is set to the parameter "#11031 Cursor pos search".
(1) Carry out the operation search to find the program to
carry out the cursor position search.
(2) Turn ON the edit/search signal.
(3) Move the cursor to the block to be carried out the cur-
sor operation search.
(4) Turn OFF the edit/search signal.
Note
(1) If the "edit/search signal" is set to ON on a screen other than the monitor screen, the "Edit/Search" window is not dis-
played. To display the "Edit/Search" window, switch to the monitor screen. Switching to the monitor screen automatically
displays the "Edit/Search" window.
(2) If a window (operation search window, menu list, guidance, etc.) other than the program edit window is displayed while
the monitor screen is being displayed, the "Edit/Search" window is not displayed even if the edit/search signal is set to
ON. To display the "Edit/Search" window, close the currently displayed window. When the currently displayed window
is closed, the "Edit/Search" window is displayed automatically.
(3) If the edit/search signal is set ON during display of the program edit window on the monitor screen, the display changes
to the "Edit/Search" window while the editing contents, cursor position, and menu etc. remain unchanged.
(4) If the "Edit/Search" window is attempted to be closed during editing, a message to confirm whether to save the data will
appear.
When it appears, if save is carried out by pressing the [Y] or [INPUT] key, the operation search will be carried out starting
from the block that has the cursor.
If save is not carried out, the edited data will be aborted, and the operation search will not be carried out.
(5) If the "Edit/Search" window is closed while the cursor is positioned in the input area during string searching or string
replacement, the operation is canceled, and the cursor returns to the editing area. After this, an operation search is car-
ried out with the block located by the cursor at the top. However, during editing, the cursor returns to the editing area,
and the same operation as that described in (3) is performed.
IB-1501453-C
The "Edit/Search" window is displayed.
The program is displayed starting from the block current-
ly searched.
(During automatic operation, the program is displayed
from its top.)
The "Edit/Search" window is closed, and the operation
search is carried out starting from the block that has the
cursor.
When the search is completed, "Search completed" is
displayed.
(Also in the case where the screen is changed with a
function key, etc. and the "Edit/Search" window is
closed, the operation search is carried out.)
338