Erasing The Tool Compensation Data - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece

5.4.3 Erasing the Tool Compensation Data

Operation method (Erasing one line of tool compensation data at the cursor position)
(1) Move the cursor to the data to be erased using the
[↑], [↓], , or
(2) Press the menu [Line clear] and the [INPUT] key.
(3) Press the [Y] or [INPUT] key.
To cancel the erasing, press a key other than [Y] or
[INPUT].
Operation method (Erasing the compensation data from compensation number 122 to 125.)
(1) Press the menu [Line clear].
(2) Input the compensation number of the data range to
be erased.
122/125 [INPUT]
(3) Press the [Y] or [INPUT] key.
To cancel the erasing, press a key other than [Y] or
[INPUT].
Note
(1) If the [INPUT] key is pressed without selecting an compensation number, the line where the cursor is located is erased.
(2) If the parameter "#11017 T-ofs set at run" is set to "1", the tool compensation amount data during automatic operation
or during pause of operation can be erased.
(3) This setting may be disabled due to the parameter "#8933 Disable lngth comp" or "8934 Disable wear comp" setting.
For details, refer to "5.4.6 Disabling the Setting of Tool Compensation Amount".
IB-1501453-C
key.
The selected line of data (one line amount) is cleared to
"0".
The cleared data is displayed at the top of the compen-
sation data.
The compensation data for the selected compensation
number is erased, and the menu highlight returns to nor-
mal.
The cleared data is displayed at the top of the compen-
sation data.
152