Mitsubishi Electric C80 Series Instruction Manual page 196

Hide thumbs Also See for C80 Series:
Table of Contents

Advertisement

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Menus (when the cursor is at [3D CHK Tool CR] of [Disp details])
Menus
Switch the display data type of the detail view of tool management data by pressing the button.
Type
switch
Select the gray color. It is also selected if the value "1" is entered.
Gray
Select the red color. It is also selected if the value "2" is entered.
Red
Select the yellow color. It is also selected if the value "3" is entered.
Yellow
Select the blue color. It is also selected if the value "4" is entered.
Blue
Select the green color. It is also selected if the value "5" is entered.
Green
Select the aqua color. It is also selected if the value "6" is entered.
Light
blue
Select the purple color. It is also selected if the value "7" is entered.
Purple
Select the pink color. It is also selected if the value "8" is entered.
Pink
This closes the pop-up window and quits this function.
Close
Menus (when the cursor is at [Use] of [Disp details])
Menus
Switch the display data type of the detail view of tool management data by pressing the button.
Type
switch
Select the [Leave blank]. This column is set to blank. It is also selected if the value "0" is entered.
Leave
blank
Select the [Outer dia.]. It is also selected if the value "1" is entered.
Outer
dia.
Select the [Inner dia.]. It is also selected if the value "2" is entered.
Inner
dia.
Select the [End face]. It is also selected if the value "3" is entered.
End
face
Switch to the tool management data list.
List
view
This closes the pop-up window and quits this function.
Close
Details
Details
171
IB-1501453-C

Advertisement

Table of Contents
loading

Table of Contents