Ignoring The Authorization Information From The Radius Server - 3Com 4200G 12-Port Configuration Manual

Configuring intrusion protection
Follow these steps to configure the intrusion protection feature:
To do...
Enter system view
Enter Ethernet port view
Set the corresponding action to
be taken by the switch when
intrusion protection is triggered
Return to system view
Set the timer during which the
port remains disabled
The port-security timer disableport command is used in conjunction with the port-security
intrusion-mode disableport-temporarily command to set the length of time during which the port
remains disabled.
If you configure the NTK feature and execute the port-security intrusion-mode blockmac command
on the same port, the switch will be unable to disable the packets whose destination MAC address is
illegal from being sent out that port; that is, the NTK feature configured will not take effect on the packets
whose destination MAC address is illegal.
Configuring the Trap feature
Follow these steps to configure port security trapping:
To do...
Enter system view
Enable sending traps for the
specified type of event

Ignoring the Authorization Information from the RADIUS Server

After an 802.1x user or MAC-authenticated user passes Remote Authentication Dial-In User Service
(RADIUS) authentication, the RADIUS server delivers the authorization information to the device. You
can configure a port to ignore the authorization information from the RADIUS server.
Use the command...
system-view
interface interface-type
interface-number
port-security intrusion-mode
{ blockmac | disableport |
disableport-temporarily }
quit
port-security timer disableport
timer
Use the command...
system-view
port-security trap { addresslearned |
dot1xlogfailure | dot1xlogoff | dot1xlogon |
intrusion | ralmlogfailure | ralmlogoff |
ralmlogon }
1-8
Remarks
—
—
Required
By default, intrusion
protection is disabled.
—
Optional
20 seconds by default
Remarks
—
Required
By default, no
trap is sent.