Binding A Static Route To A Bfd Session - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Step 6 Run:
commit
The configurations are committed.
----End

2.4.4 Binding a Static Route to a BFD Session

When binding a static route to a BFD session, ensure that the static route resides on the same
link as the BFD session.
Context
Perform the following steps on the router to bind a static route to a BFD session:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip route-static ip-address { mask | mask-length } { nexthop-address | interface-
type interface-number [ nexthop-address ] } [ preference preference | tag tag ]
track bfd-session bfd-name [ description text ]
A BFD session is bound to the IPv4 static route on the public network.
----End
2.4.5 Checking the Configurations
After BFD for static route is configured, you can check information about BFD sessions and
BFD for static route.
Prerequisites
BFD configurations for IPv4 static routes are complete.
Issue 02 (2014-09-30)
NOTE
The local discriminator of the local device corresponds to the remote discriminator of the remote device,
and the remote discriminator of the local device corresponds to the local discriminator of the remote device.
The local discriminator of the local device must be the same as the remote discriminator of the remote
device. Otherwise, the session cannot be correctly set up. After the local and remote discriminators are
configured, they cannot be modified.
NOTE
When setting up a BFD session, you must run the commit command after configuring necessary
parameters, such as local and remote discriminators; otherwise, the session cannot be set up.
NOTE
When binding a static route to a BFD session, ensure that the static route resides on the same link as the
BFD session.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 IP Static Route Configuration
*
103