Huawei Quidway NetEngine80E Configuration Manual page 92
Universal service router, ip routing
Hide thumbs
Also See for Quidway NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (341 pages) ,
- Installation manual (169 pages)
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Assign IP addresses to interfaces.
# Create VLAN 10 on the RSG and add GE 1/0/0 and GE 2/0/0 to VLAN 10.
<RSG> system-view
[RSG] interface gigabitethernet 1/0/0
[RSG-GigabitEthernet1/0/0] portswitch
[RSG-GigabitEthernet1/0/0] quit
[RSG] interface gigabitethernet 2/0/0
[RSG-GigabitEthernet2/0/0] portswitch
[RSG-GigabitEthernet2/0/0] quit
[RSG] vlan 10
[RSG-vlan10] port gigabitethernet 1/0/0
[RSG-vlan10] port gigabitethernet 2/0/0
# Assign IP addresses to physical interfaces. For detailed configurations, see configuration files
in this example.
Step 2 Configure OSPF to enable devices to communicate with each other. The details are not provided
here.
Step 3 Configure a VRRP backup group.
# Create backup group 1 on UPE1 and set the priority level of UPE1 to 120 so that UPE1 functions
as the master.
<UPE1> system-view
[UPE1] interface gigabitethernet 2/0/0
[UPE1-GigabitEthernet2/0/0] vrrp vrid 1 virtual-ip 20.1.3.111
[UPE1-GigabitEthernet2/0/0] vrrp vrid 1 priority 120
[UPE1-GigabitEthernet2/0/0] vrrp vrid 1 timer advertise 10
[UPE1-GigabitEthernet2/0/0] quit
# Create backup group 1 on UPE2 and set the priority level of UPE2 to 100 (the default value)
so that UPE2 functions as the backup.
<UPE2> system-view
[UPE2] interface gigabitethernet 2/0/0
[UPE2-GigabitEthernet2/0/0] vrrp vrid 1 virtual-ip 20.1.3.111
[UPE2-GigabitEthernet2/0/0] quit
Step 4 Verify the configuration.
# After the preceding configuration, run the display vrrp command on UPE1 and UPE2. You
can view that the VRRP status of UPE1 is Master and the VRRP status of UPE2 is Backup. The
command output on UPE1 and UPE2 is as follows:
[UPE1] display vrrp
GigabitEthernet2/0/0 | Virtual Router 1
Issue 02 (2014-09-30)
VLAN ID
ID and virtual IP address of a VRRP backup group
Priority level of each device in a VRRP backup group
Link cost of an interface associated with a VRRP backup group
State : Master
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Routing Basic Configuration
67
Hide quick links:
Advertisement
