Configuring The Route Attributes Of A Vpn Instance - Huawei Quidway S9300 Configuration Manual
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
3 BGP/MPLS IP VPN Configuration
To prevent excessive routes from being imported to the PE, set the maximum number of routes
supported by a VPN instance.
----End
3.5.3 Configuring the Route Attributes of a VPN Instance
Procedure
l
3-24
Configuring the Hub-PE
1.
Run:
system-view
The system view is displayed.
2.
Run:
ip vpn-instance vpn-instance-name1
The VPN instance view of the VPN-in is displayed.
3.
Run:
vpn-target vpn-target1 &<1-8> import-extcommunity
The VPN target is configured for the VPN instance. Then, the VPN instance can
receive the VPNv4 routes advertised by the Spoke-PEs.
vpn-target1 contains all the outbound VPN target values of the Spoke-PE.
4.
(Optional) Run:
import route-policy policy-name
The import routing policy of the VPN instance is configured.
5.
(Optional) Run:
export route-policy policy-name
The export routing policy of the VPN instance is configured.
6.
Run:
quit
Return to the system view.
7.
Run:
ip vpn-instance vpn-instance-name2
The VPN instance view of the VPN-out is displayed.
8.
Run:
vpn-target vpn-target2 &<1-8> export-extcommunity
The VPN target attribute is configured to advertise the routes of the Hub sites and
Spoke sites.
vpn-target2 contains all the inbound VPN target values of the Spoke-PE.
9.
(Optional) Run:
import route-policy policy-name
The import routing policy of the VPN instance is configured.
10. (Optional) Run:
export route-policy policy-name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Issue 03 (2009-08-20)
Advertisement
Table of Contents
