Huawei Quidway NetEngine80E Configuration Manual page 69

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Step 2 Configure a cost for ARP Vlink direct routes and routes to the directly connected network
segment on the L3VE sub-interface of the secondary PW.
1.
2.
3.
4.
5.
Issue 02 (2014-09-30)
quit
Return to the system view.
Run:
interface virtual-ethernet interface-number
A VE interface is created, and the VE interface view is displayed.
Run:
ve-group ve-group-id l3-access
The VE interface is configured as an L3VE interface that accesses a BGP/Multiprotocol
Label Switching (MPLS) IP VPN and bound to a VE group.
NOTE
The L2VPN can access the L3VPN only if the Layer 2 Virtual Ethernet (L2VE) and L3VE interfaces
are bound to the same VE group and reside on the same board.
Run:
quit
Return to the system view.
Run:
interface virtual-ethernet interface-number.subinterface-number
A VE sub-interface is created, and the VE sub-interface view is displayed.
Run:
direct-route cost cost
A cost is configured for ARP Vlink direct routes and routes to the directly connected
network segment on the L3VE sub-interface of the secondary PW.
By default, the cost of ARP Vlink direct routes and routes to the directly connected network
segment on L3VE sub-interfaces is 0.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Routing Basic Configuration
44