Huawei Quidway NetEngine80E Configuration Manual page 66

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
direct-route ipv6 track pw-state deactive-standby
The device is configured to deactivate the IPv6 network segment route that corresponds to the
L3VE sub-interface of the secondary PW.
----End
Checking the Configurations
Before you configure the direct-route ipv6 track pw-state deactive-standby command on an
AGG, run the display ipv6 routing-table vpn-instance vpn-instance-name command on the
AGG. The command output shows the IPv6 network segment route that corresponds to the L3VE
sub-interface of the secondary PW.
<HUAWEI> display ipv6 routing-table vpn-instance vrf1
Routing Table : vrf1
Destination
NextHop
Cost
RelayNextHop : ::
Interface
Destination
NextHop
Cost
RelayNextHop : ::
Interface
Destination
NextHop
Cost
RelayNextHop : ::
Interface
After you configure the direct-route ipv6 track pw-state deactive-standby command on an
L3VE sub-interface of the secondary PW, run the display ipv6 routing-table vpn-instance
command on the AGG. The command output shows no IPv6 network segment route that
corresponds to the L3VE sub-interface of the secondary PW.
<HUAWEI> display ipv6 routing-table vpn-instance vrf1
Routing Table : vrf1
Destination
NextHop
Cost
RelayNextHop : ::
Interface
Destination
NextHop
Cost
RelayNextHop : ::
Interface
Issue 02 (2014-09-30)
NOTE
The direct-route ipv6 track pw-state deactive-standby command cannot be configured together with
the direct-route ipv6 track pw-state or direct-route ipv6 degrade-delay command on one L3VE sub-
interface. If you configure any two of these commands, the latest configuration overrides the previous one.
Destinations : 3
: 2001:db8::
: 2001:db8::1:1
: 0
: Virtual-Ethernet1/0/1.1
: 2001:db8::1:1
: ::1
: 0
: Virtual-Ethernet1/0/1.1
: FE80::
: ::
: 0
: NULL0
Destinations : 2
: 2001:db8::1:1
: ::1
: 0
: Virtual-Ethernet1/0/1.1
: FE80::
: ::
: 0
: NULL0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Routes : 3
PrefixLength : 64
Preference
Protocol
TunnelID
Flags
PrefixLength : 128
Preference
Protocol
TunnelID
Flags
PrefixLength : 10
Preference
Protocol
TunnelID
Flags
Routes : 2
PrefixLength : 128
Preference
Protocol
TunnelID
Flags
PrefixLength : 10
Preference
Protocol
TunnelID
Flags
1 IP Routing Basic Configuration
: 0
: Direct
: 0x0
: D
: 0
: Direct
: 0x0
: D
: 0
: Direct
: 0x0
: D
: 0
: Direct
: 0x0
: D
: 0
: Direct
: 0x0
: D
41