Enabling Public Network Ipv6 Frr - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
route-policy route-policy-name { permit | deny } node node
The route-policy node is created and the route-policy view is displayed.
Step 3 (Optional) Run:
if-match
Matching conditions are set to filter the routes to be backed up.
Select the if-match clauses according to
Clause.
If no matching condition is specified, backup interfaces and backup next hops will be configured
for all IPv6 routes of the router. To correctly configure backup relationship between routes,
specifying matching conditions is recommended.
Step 4 Run:
apply ipv6 backup-interface interface-type interface-number
The backup outbound interface is set.
Step 5 Run:
apply ipv6 backup-nexthop ipv6-address
The backup next hop is set.
----End

1.5.3 Enabling Public Network IPv6 FRR

Public network IPv6 FRR can be configured to switch traffic to a backup link when the active
link becomes unavailable, preventing long time service interruption.
Context
Perform the following steps on the router to which IPv6 FRR needs to be applied:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ipv6 frr route-policy route-policy-name
IPv6 FRR is enabled.
By default, IPv6 FRR is disabled.
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Routing Basic Configuration
10.3.3 (Optional) Configuring the If-Match
17