Assigning A Vlan Id; Paging Through The Port List - Enterasys 2H25x User Manual

Port Assignment Configuration Screen
7.4.2

Assigning a VLAN ID

The Port Assignment Configuration screen also enables the user to set each port's VLAN ID (VID)
by stepping through a list of all configured VLANs. To assign a VLAN ID to a port in this manner,
perform the following steps:
NOTE: It may be necessary to use the NEXT and PREVIOUS commands to page
through the available ports. For instructions, refer to
1. Use the arrow keys to highlight the VLAN ID field for the port combination you wish to change.
2. Use the SPACE bar or BACKSPACE key to step sequentially through the previously configured
VLAN ID numbers. Only existing VLAN IDs will be displayed.
NOTE: New VLAN IDs must be created with the functions available on the Device
VLAN Configuration screen, discussed in
3. When the desired VLAN ID is displayed, use the arrow keys to highlight the SAVE command
at the bottom of the screen.
4. Press ENTER. The message "SAVED OK" displays.
7.4.3

Paging Through the Port List

To display additional ports that do not display in the current screen, use the NEXT or PREVIOUS
commands at the bottom of the screen, as follows:
NOTE: The NEXT and PREVIOUS fields will only display if there are further Port List
entries to page through.
1. To display the next screen, use the arrow keys to highlight NEXT. Press ENTER to view the
entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight PREVIOUS. Press ENTER to
view the entries on the previous screen.
7-14 802.1Q VLAN Configuration Menu Screens
Section 7.4.3.
Section 7.3.