For information about...
show rmon filter
set rmon filter
clear rmon filter
show rmon channel
Use this command to display RMON channel entries for one or more ports.
Syntax
show rmon channel [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, information about all channels will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON channel information for
B3(rw)->show rmon channel ge.2.12
Port ge.2.12
----------------------------------------------------------
Control
OnEventIndex
EventIndex
Matches
Description
Owner
set rmon channel
Use this command to configure an RMON channel entry.
Syntax
set rmon channel index port-string [accept {matched | failed}] [control {on | off}]
[description description] [owner owner]
Parameters
index
port‐string
(Optional) Displays RMON channel entries for a specific port(s).
Channel index= 628
off
AcceptType
0
OffEventIndex
0
Status
4498
Thu Dec 16 12:57:32 EST 2004
NetSight smith
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 2. Maximum value is 65535.
Specifies the port on which traffic will be monitored.
.2.12:
ge
EntryStatus= valid
matched
0
ready
SecureStack B3 Configuration Guide 14-15
show rmon channel
Refer to page...
14-17
14-17
14-18