Error Messages; Editing Features - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
In the above example the notation 1/0/1 was used. The terminology for each parameter is as follows:
•
Interface Unit's ID / Open Slot's ID / Port's ID
The Interface Unit's ID is the ID of the stacking unit without the physical stack. If stacking is disabled or
this unit is a stand-alone unit, then this parameter is irrelevant. The Open Slot's ID is the ID of the module
plugged into the open module slot of the switch. The DXS-3600 Series switch doesn't support any open
modules slots, thus this parameters will always by zero for this switch series. Lastly, the Port's ID is the
physical port number of the port being configured.
In summary the above example will configure the stacked switch with the ID of 1, with the open slot ID of
0, and the physical port number 1.

Error Messages

When the users issue a command that the switch does not recognize, error messages will be generated
to assist users with basic information about the mistake that was made. A list of possible error messages
are found in the table below.
Error Message
Ambiguous command
Incomplete command
Invalid input detected at
^marker
The following example shows how an ambiguous command error message is generated.
Switch# show v
Ambiguous command
Switch#
The following example shows how an incomplete command error message is generated.
Switch# show
Incomplete command
Switch#
The following example shows how an invalid input error message is generated.
Switch# show verb
Invalid input detected at ^marker
Switch#

Editing Features

The command line interface of this switch supports to following keyboard keystroke editing features.
Meaning
Not enough keywords were entered for the switch to recognize the
command.
The command was not entered with all the required keyword.
The command was entered incorrectly.
^
7