Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
3. 802.1X Commands
3-1 clear dot1x counters
This command is used to clear 802.1X counters (diagnostics, statistics and session statistics).
clear dot1x counters {all | interface INTERFACE-ID [, | -]}
Parameters
all
interface INTERFACE-ID
,
-
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to clear 802.1X counters (diagnostics, statistics and session statistics).
Example
This example shows how to clear 802.1X counters (diagnostics, statistics and session statistics) on the
Ethernet port 1/0/1.
Switch# clear dot1x counters interface ethernet 1/0/1
Switch#
3-2 dot1x control-direction
This command is used to configure the direction of the traffic on a controlled port as unidirectional (in) or
bidirectional (both). Use the no form of the command to reset to the default setting.
dot1x control-direction {both | in}
no dot1x control-direction
Parameters
Specifies to clears 802.1X counters (diagnostics, statistics and session
statistics) on all interfaces.
Specifies to clears 802.1X counters (diagnostics, statistics and session
statistics) on the specified interface. Valid interfaces are physical ports
(including type, stack member, and port number).
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No space is allowed before and after
the comma.
(Optional) Specifies a range of interfaces. No space is allowed before
and after the hyphen.
24