Dhcpv6 Client Commands - D-Link DXS-1210-12TC Reference Manual

14. DHCPv6 Client Commands

14-1
This command is used to display the DHCPv6 related settings on the interface.
show ipv6 dhcp interface [INTERFACE-ID]
Parameters
INTERFACE-ID
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Use this command to display the device's DHCPv6 DUID or use the show ipv6 dhcp interface
command to display DHCPv6 related setting for interfaces. If the interface ID is not specified, all
interfaces with the DHCPv6 function will be displayed.
Example
This example shows how to display the DHCPv6 setting for interface VLAN 1, when VLAN 1 is
DHCPv6 disabled.
Switch# show ipv6 dhcp interface vlan1
vlan1 is not in DHCPv6 mode.
Switch#
This example shows how to display the DHCPv6 setting for all VLANs. Only VLANs that are DHCPv6
enabled are displayed.
Switch# show ipv6 dhcp interface
vlan1 is in client mode
Rapid-Commit: disabled
Switch#
DXS-1210 Series Smart Managed Switch CLI Reference Guide
show ipv6 dhcp
(Optional) Specifies the VLAN interface to display the DHCPv6 related
settings.
113