Toe - Subaru XT 1988 Service Manual

1-4 PRE-DELIVERY INSPECTION
Toe L
=
B-A (In case of ilL" being positive: L
=
toe-in)
\In case of ilL" being negative: L
=
toe-out
FWD
4WD
~
Normal Minimum Maximum Normal Minimum Maximum
mm
0(0)
3 (0.12) 3 (0.12)
5 (0.20)
2 (0.08) 8 (0.31)
(in)
IN OUT OUT
OUT OUT
Service limit
i - - - - - - - - - -
-----
-
- ---
- - - -
---- - - - -
- . - -
- - -
Degree: per wheel 0° 0°09' IN 0°09' OUT 0°15' OUT
0°06' OUT
0°24' OUT
Toe
mm
0(0)
1 (0.04) 1 (0.04)
5 (0.20)
4 (0.16)
6 (0.24)
(in)
IN OUT
OUT
OUT OUT
·Service standard i - - - - - - - - - -
- - - -
I - -
- -
_
........
- - . -
-
- -
r- - - - -
-
- . - . . - . . . .
Degree: per wheel 0° 0°03' IN 0°03' OUT 0°15' OUT 0°12' OUT 0°18' OUT
Side-slip with
Service limit m/km (ft/mile) IN 5 - OUT 5 (IN 26 - OUT 26)
one occupant
"Service standard m/km (ft/mile) IN 3 - OUT 3 (IN 16 - OUT 16)
"If the toe data is out of "SERVICE LIMIT", readjust it within "SERVICE STANDARD".
a. Before checking front wheel alignment with a sideslip
tester, check the following:
(1) Left and right tires are the same type and size.
(2) Tires are inflated to specified pressure.
b. When driving over the sideslip tester, be sure to drive the
vehicle slowly with the steering wheel fixed in the straight
ahead position.
4)
If the measured toe or sideslip value is not within the
standard range, adjust it as follows:
(1)
Loosen the lock nut on the right and left tie-rod ends,
and adjust the right and left tie-rods simultaneously.
Turn both tie-rods equally to make the adjustment.
(2)
Measure the amount of toe or sideslip, and if the
measured value is within the specified range, tighten the
tie-rod end lock nuts.
Tightening torque (lock nut
I :
78 - 88 N·m (8.0 - 9.0 kg-m, 58 - 65 ft·lb)
After completing the toe adjustment, check the steering wheel
for levelness when the vehicle is in the straight ahead position.
26
4. UNDERSIDE
CHECK POINTS
1. Leakage of engine oil, transmission gear oil,
differential gear oil, etc.
2. Leakage of coolant
3. Leakage of brake fluid
4. Loose suspension mountings or steering
mounting
Raise the vehicle body and perform these checks from the
underside by referring to the "Preparatory Steps for Underside
Inspection" instructions.
1.
Visually check for any signs of engine oil, transmission
gear oil, differential gear oil, etc. leakage.
2. Visually check for any sign of coolant leakage.
3. Visually check for any sign of brake fluid leakage.
4. Check the suspension mounting and steering mounting for
any loose or unconnected parts.